Start a new topic

Problem while printing

 Hello everybody,

I am new in the 3D printing world and as I am doing my first printings I still need some advices from more skilled people!

The problem I have is that my printer will always stop at the same point because the filament gets stuck and winds up the motor of the extruder! Furthermore I cant get very nice printings, they are all brittle!

In the picture I uploaded you can see my printing (right) and a previous printing from the person that was working with the printer before me!

I think the problem is with noth enough filament coming out and therefore it gets then stuck in the motor wheel!

Can someone help me telling which settings i should change insimplify3D?


Thank you very much,


Fausta


Dear Montalbetti Fausta,


If you would be so kind as to tell me what type of 3D printer you own I will help you get better results.


Also if you could send me the factory file of a print you want to make so I can have a look at the print settings I would really appreciate it.



Dear Mircea.O,

I have the same problem with severalprints. The first 2-3mm the printer works properly, but after that I have the same result as the pictures above.

My printer is a leapfrog creatr HS.µ

Thanks!

Tijs.

try this: measure exact filament diameter and use correct value

do not use cooling fan


Login or Signup to post a comment

User Manual

Simplify 3D
Creater by Materialise
Repetier

Quick Start Guide

Filament Setting Guide

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Software Video Library