Start a new topic

CreatrHS strange behavior when starting a print

Does this behavior seem normal to anyone? When I start a print, when it draws the boundary around the print area, it seems to have a really hard time, it glitches and pauses sometimes making a lot of noise. However, when the print starts, it prints with normal movement.


Start of Print:



After Print Begins:


1 person has this problem

the start print video isn't working. Here it is again:


I sometimes get this, not quite as bad as your video though. I put it down to the way simplify3D has to increase the outer perimeter to make the skirt/brim. I assume it takes the original mesh points, moves them away, and extrapolates between them. This extrapolation doesn't create very smooth movements. I could be wrong but that's the conclusion I drew

 

Login or Signup to post a comment

User Manual

Simplify 3D
Creater by Materialise
Repetier

Quick Start Guide

Filament Setting Guide

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Software Video Library