Start a new topic

Old Forum

Very interresting that after the deletion of the old forum, also the topic with the discussion about the reasons was closed by admin.

So I tel it again. Without the tips and tricks of the experienced users there and the changes of the creatr that where included, the creatr never ould have printed ABS in a acceptable way.

And as you can see on the closed topic, this forum is very much influenced by leapfrog. So mayby the other forum at


 is a better place to post you knowledge without the risk to be influenced.

Lets see how long this will be online.

Maybe a screenshot can keep it alive.

I would also very much like to have all that information back.

Until this new forum attracts some more attention, and until it becomes readable on my browsers (the light-grey and green text is almost invisible), I will be using:

Anyone who has a record of older forum entries, please post it back.  Haven't found anything back on Google yet.



I have a dual Creatr purchased in 2012.  I found that forum extremely valuable and wish to again have access.  Surely someone could provide a link..

I think the old forum is gone for good.
It's not very active but you may want to check here:


thank you.

Login or Signup to post a comment

User Manual

Simplify 3D
Creater by Materialise

Quick Start Guide

Filament Setting Guide

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Software Video Library